Force-balance broadband digital seismometer CME-6011ND

CME-6011ND is a force-balance broadband digital seismometer. 

A bandwidth of up to 30 sec provides recording of the remote seismic events. 

This seismometer combines the low-noise molecular-electronic sensing element (transducer) and the electrodynamic force-balance that result in a very flat response over a wide frequency range, a high dynamic range and a greatly improved time and temperature stability of the parameters. 

This model is very rugged and does not require any special means or procedures for transportation and installation. The only procedure to start the operation is to place the seismometer on a rigid horizontal surface, turn the power on and wait for several minutes. 

This seismometer can be used in various applications including seismic observatories, seismological surveys, seismic microzoning and passive broadband seismic exploration.

Click here for available downloads to operate CME-6011ND. If the FTP-connection fails, right-click to copy the link and open it with Windows Explorer.

Characteristics Delivery and warranty

Frequency range 0.033 Hz (30 sec) - 50 Hz
Sensitivity 2000 V/(m/sec)
Clip level ±20 V or ±10 mm/sec
Self noise at 1 Hz 2.5 nm/sec (5.0 µV)
Dynamic range 132 dB at 1 Hz
Nonlinearity 0.2 %
Sensitivity axes Vertical, North, East
Supply voltage 12 - 24 V Nominal (9 - 36 V permissible)
Power consumption 1.2 W nominal / 3.25 W peak
Temperature range -40...+55°C
ADC sampling rate 1, 5, 10, 25, 50, 100, 125, 250, 500, 1000 Hz
Maximum installation tilt ±15°
Case connectors MS-3102 10-pin multipurpose male connector, SMA-M for an active/passive GPS antenna, SMA-M for Wi-Fi antenna, USB-B high-speed port
Dimensions 204 x 238 mm (diameter x height with handle)
ADC resolution 24 bit
Weight 7.0 kg
ADC noise performance 21.6 bits noise-free resolution at 100 sps
Gain coefficients 1, 2, 4, 8, 12
Case material Aluminum, stainless steel
Data recording mode continuous, schedule
Data recording format internal; binary (float), miniSEED, SEG-Y, ASCII, SAC converters provided
Data storage microSD 32 GB
Data transfer USB 2.0, Wi-Fi
Cross-axes sensitivity -60 dB
Inbuilt sensors for device health monitoring Main supply voltage, temperature, compass, tilt
Cold-start time 5-15 min
Leveling, mass locking none required
Delivery set 1.5 m 10-pin connector power cable with pigtails; 1.5 m 10-pin/USB-A + power pigtails connectors digital cable; digital USB A/B cable; Wi-Fi SMA-M antenna for installation on the case; 5 m cable GPS antenna; 3 leveling feet; technical passport
GNSS receiver GPS / GLONASS
GNSS timing accuracy < 1µs